- Lekez
- Posts : 3
Join date : 2019-01-12
Bearing housing alignment
Sun Feb 10, 2019 10:44 pm
Hi guys I am really building my yoke after a successful first attempt. I do have an issue aligning the bearing and the housing, do you have any tips on how to do it?
Thanks Abbas.
Thanks Abbas.
Re: Bearing housing alignment
Wed Feb 20, 2019 9:05 pm
Hi Abbas
I would suggest not to tighten the three bolts around the "triangle corners" until you got the 25mm pipe in place.
These bearing are self-aligning so you need to insert the axis and then tighten the housing halves together.
Jay
I would suggest not to tighten the three bolts around the "triangle corners" until you got the 25mm pipe in place.
These bearing are self-aligning so you need to insert the axis and then tighten the housing halves together.
Jay
Permissions in this forum:
You cannot reply to topics in this forum
|
|